Next up on the right wing is to place the landing lights. In the QuickBuild, they supplied 3 wires for the landing light.
I assumed that this meant there should be an inner and outer landing light positive line and a shared negative line. I first had to determine which lines led to ones on the other end, pretty easy to do with a battery and voltage meter. Once the lines were identified I used my label maker to print out labels for each. I then soldered the negative line to 2 other wires and covered with heat shrink. Placing the lights took some time as the angle isn’t that easy for holding everything in place and fitting the screws. It all eventually fit after some finagling. Comments are closed.
|
Archives
September 2021
Categories
All
|