Today I worked on installing the seatbelts. Unspooling the belts was a challenge since the locking mechanism is gravity sensitive. Meaning, there’s a ball in the spool that has to be oriented a specific way for the spool to release. Once I figured that out, unspooling the belt was pretty easy.
The kit didn’t come with the penny washers that are in the instructions, but did come with some M8 penny washers that seemed to be close enough. I also see there’s some seat belt centering bushings, but I’m not sure where those go. I have a question out to the factory. I also put together another floor panel that covers the flap and elevator controls torque tube assembly under the front seats. Now I just need to start installing the numerous M4 Rivnuts in the center fuselage, an item I’ve been putting off due to it just being a laborious task... Update 1/31/20: I received word from the factory that there is a steel bracket that is already embedded into the canopy. The CAD drawing of the bracket is below. I enlarged the hole a bit and finally was able to see the bracket. Comments are closed.
|
Archives
September 2021
Categories
All
|