While I wait for additional shipments, I decided to try and place the center console skins to check fit.
However, that means installing a good amount of rivnuts in the center console ribs and floor. Almost all of the rivnut holes had to be upsized to M4. I think at some point the factory switched from M3 to M4. Some places were a tight fit, so I used the angle drill bit to help reach some spots. The step drill doesn’t do the best job with creating a clean cut, so every hole also needed to be deburred pretty heavily. I began fitting the skins and built up the center console box that fits above the flap actuator. Things we’re going smoothly until I placed the bottle skin that fits along the main spar. It seems the space between the rib that holds the flap actuator and the main spar was too small for the skin. I emailed TAF about this and they said to check the alignment of the fuselage forward or the spar. This was a QuickBuild and the side skins were already on, so the alignment should be correct. I’ll be looking at what options I have to get it to fit. I might just have to move the rib a bit forward to get things to line up. Comments are closed.
|
Archives
September 2021
Categories
All
|