The next pile of metal on the inventory shelves was the back seat. I inventoried everything and laid out the parts I need, from there it was just a matter of clecoing everything together. I started with the seat back rests and will do the bottoms next along with the seat brackets.
The only issue I had was the bottom angled channel where some holes didn’t line up. I’ll just drill new ones since the holes are offset about half way. A difficult piece to put on was the last channel that fits between the head rests. Since it has to fit over the skins, it was a tight fit. Had to use a rubber mallet to get the holes cleco’d into place! Comments are closed.
|
Archives
September 2021
Categories
All
|